The inlet hose for the washing machine is leaking, leaking
If you notice that your washing machine has started to leak, this can happen for various reasons. Including due to a leak in the inlet hose. At first glance, it seems that solving the inconvenience that has arisen is not quite difficult. But it is not always the case. And this malfunction can cause some problems. You may decide that in order to fix the damage, you just need to tighten the hose connections harder. Unfortunately, this method does not always help. Let's take a closer look at this issue and discuss the typical places in the hose where leaks most often occur. And some reasons that can cause this.
Not a reliable enough connection
One of the reasons for a water leak may be an insufficiently reliable connection between the hose and the water pipe or washing machine. Or wear of the rubber gasket, which is located at the joints of the hose. Over time and under the influence of mechanical factors, it may slightly change its shape. May become less elastic. This is what will cause a leak. Typically, this problem occurs after moving the washing machine. Or after moving it to another apartment and a new installation.
In order to get rid of this problem, just buy a new gasket and install it in place of the old one. Gaskets can be purchased at plumbing supply stores. In order not to be mistaken in size, you can take an old gasket with you and compare it with the one you will buy.Gaskets cost mere pennies, there are usually quite a lot of them in such stores, so there shouldn’t be any problems with the purchase.
Incorrect hose position
It is necessary that the hose is in the correct position in relation to the connection points with the washing machine and the water pipe. The part of the inlet hose that is made of plastic and is located inside under the rubber gasket must be in the correct position. Such that, in a twisted state, it will evenly press on the gasket from all sides. If there is less pressure in some part, then water leakage may occur there.
If this is the problem of leakage, then it is enough to correctly place the inlet hose of the washing machine and tighten its connecting points a little more tightly.
Poor joining of plastic and rubber components in the hose
A leak may also appear inside the hose. Where its plastic and rubber components meet. They are fixed to each other using a metal frame. The reason may be that the part of the hose that is made of rubber has lost its elasticity over time, worn out, and changed shape. In such a situation, the pressure of the fixing metal band may become weaker. And this will lead to a leak.
This problem also occurs when moving the machine, changing its location or moving. If this malfunction occurs, you should try tightening the fastener further. You can also fix the hose in a position in which water will not leak. But all these are just temporary solutions. And we do not recommend resorting to them because the leak may resume. The recommended solution to this problem is to replace the hose. You can easily find a new hose in stores that sell plumbing supplies.The hoses are again not expensive and such a purchase will not put a strain on the family budget.
Replacing the hose
Replacing the inlet hose is very simple. You just need to turn off the water supply. Then unscrew the old hose from the water supply and from the washing machine. And then screw on the new hose. After this, open the water supply and examine the hose for leaks.
If you did everything correctly, then they will not exist. If they appear, it means that you did not tighten the connections tightly enough, or you lost the gasket. You also need to pay attention to the fact that these places cannot be twisted. Because if you tighten it too tightly, you can strip the threads or damage the gasket. And if you have a lot of strength, then do it carefully.
It also happens that there is a leak from the rubber part of the hose. It appears due to improper use, mechanical damage and other cases. With such a breakdown, there is no need to be too smart. You can simply replace the damaged hose with a new one.
Interesting:
1 reader comment
OK