Turning on the Gorenje washing machine
Figuring out how to turn on a Gorenje washing machine is very simple: just read the factory instructions once. Especially if there was already any other machine in the house - the scheme for turning on and controlling the washing machines is the same, regardless of the brand. You just need to think and look at the dashboard. For beginners, the first launch can be a challenge. We suggest not to practice the “poke method”, but to turn on the system and set up the cycle strictly according to the instructions.
Putting the new machine into operation
A Gorenje washing machine just delivered from the store will not be ready for washing. The machine must be prepared for the start of the first cycle. First, the unit must “stand” at room temperature for several hours, and then “clean” itself of factory stickers and markings. Afterwards, the transport bolts are unscrewed and the connection to the communications is established. It is important to do everything according to the instructions: taking into account regulations and safety requirements.
Before operating the Gorenje washing machine, it is necessary to remove the transport bolts - it is prohibited to turn on the machine without removing them!
The washing machine connected to the communications can be started. But don’t rush to load the laundry - first you need to “run” the machine idle. We are talking about a technical cycle, which necessarily takes place on a high-temperature program with an empty drum, but with detergent. This move will solve three problems at once:
- the machine will be washed from factory grease and dust;
- the characteristic chemical smell will go away;
- The washing machine will be checked for functionality (whether water is being filled, the tank is emptying, whether the heating element is working, etc.)
Sometimes you can't start the wash the first time.As a rule, the machine’s refusal to work is explained by an error code on the display. More often, the problem is a loosely locked hatch door, which, out of habit, is scary to press too hard against the body. It is rare, but it happens that the machine does not turn on due to a manufacturing defect, installation problems or other malfunction. In such cases, it is advisable to contact the service for diagnostics.
We wash correctly - an algorithm for every day
If the technical launch was successful and did not reveal any problems, then you can start a normal wash. But if any high-temperature program was turned on the first time, then the second time you should take a more serious approach to choosing a mode. When searching for a suitable button, you need to focus on the type and color of the laundry, as well as the degree of soiling of the fabrics.
Choose a washing program based on the type and color of the fabric, as well as the degree of soiling!
Modern Gorenjes offer the user a wide range of software: dozens of basic and unique modes. However, beginners are easily lost among the abundance of buttons and lights on the dashboard. Meanwhile, deciphering the designations is very simple - just open the corresponding section of the factory instructions and study the functionality offered by the machine. To start washing clothes, proceed as follows:
- insert the power cord from Gorenje into the socket;
- turn the water tap;
- put pre-sorted laundry into the drum (remember the minimum and maximum load weight);
- close the hatch tightly;
- open the powder receptacle and add detergent (we will describe in detail below where and how much);
- press the “On” button;
- scroll the programmer to the desired program;
- We start the cycle by clicking on “Start/Pause”.
All! All you have to do is wait for the machine to complete the cycle, signaling the end of the program with a sound signal. But even after the melody, do not rush to open the hatch immediately - the electronic locking is removed only after 3-5 minutes.
Add detergent
Choosing the right mode is only half the success. The second lies in the detergent. It is important to select and add the powder correctly, otherwise the laundry will not be washed or, on the contrary, will remain soapy. A few tips will help you avoid mistakes:
- choose natural compositions, preferably gel ones;
- dose the product correctly, following the instructions for the powder;
- use measuring spoons and caps;
- Do not confuse the powder receptacle compartments.
The last point is among the most important. The fact is that most Gorenje washing machines have a dispenser with three compartments. The left one is for the main wash, the far right is for the preliminary wash. Only liquid additional products, conditioners, rinses and softeners are poured into the central cuvette. If you mix up the compartments, the quality of the wash will suffer greatly.
Use the machine carefully
Modern washing machines attract with simple and intuitive controls. Gorenje is no exception - just reading the instructions is enough to understand the principle of its operation. But in order for the machine to serve for a long time and trouble-free, it is necessary not only to be able to turn on the system, but also to properly care for the equipment. So, it is recommended to follow a few basic rules.
- Monitor the weight of the laundry placed in the drum (each washing machine has both a maximum and minimum permissible loading weight).
- Wipe the Gorenje body, as well as the hatch cuff and drum after each use.
- After washing, leave the hatch door and tray open for natural drying.
- Do not store objects, especially heavy ones, on the lid.
- Do not adjust the settings after starting the wash - the electronics may freeze.
- Measure the hardness of your tap water and use softeners if necessary.
With a washing machine from Gorenje you can make your life much easier, getting clean clothes without any effort. The main thing is to operate the machine correctly, do not overload, do not confuse the modes, clean it regularly and use only high-quality detergents.
Interesting:
3 reader comments
What does the container mean: 1 dot, 2 dots and a flower? What do you add to it for washing?
1st point – pre-wash (soaking). 2 points – main wash. Flower – compartment for air conditioner. For most programs, simply pouring powder into the two-point compartment is sufficient. The rest is optional.
How to set the desired temperature manually?