How to adjust the legs of a Bosch washing machine?

How to adjust the legs of a Bosch washing machine If, after the first launch, the new washing machine began to “jump”, “wobble” and vibrate strongly, most likely mistakes were made during its installation. Even if the floor in the room visually seems perfectly level, this may not be the case. In this case, adjusting the legs of the Bosch washing machine will help. We'll tell you how to do it correctly.

How to adjust the legs?

It is not difficult to adjust the automatic machine. To complete the work you will need a building level. Using the device, you can quickly level the equipment.

First of all, evaluate the space allocated for the washing machine. The surface must be level. Otherwise, it doesn’t matter what the floor covering will be: tiled or parquet, the equipment will be “out of whack” in any case. At the slightest vibration, the machine will move around the room.

It is important to level the floor before installing and adjusting the washing machine.

If an uneven floor is not your case, you can begin installing the washing machine. First, evaluate how the equipment stands up. Carefully rock the machine back and forth to the sides. This will make it clear which racks need to be adjusted.

The adjustment process consists of unscrewing the washer on the leg of the automatic machine and raising the support to the desired height. The stand can be rotated from left to right or in the opposite direction.

correct adjustment of the legs

You can verify the accuracy of the adjustment using a building level. The device is placed on top of the washing machine. The “bubble” on the instrument should “freeze” in the center. This will indicate that the machine is placed perfectly level.

When installing a washing machine, you can take into account “folk” life hacks. According to craftsmen, such measures help securely fix the washing machine in place. The first tip is to place a sheet of plywood under the equipment, the size corresponding to the bottom of the machine. The plywood rectangle is attached to the floor using liquid nails.

Another, slightly dubious option is to wash the floor under the machine with sweet water. Thanks to this procedure, the washing machine sticks to the floor and does not move even with the most intense spin cycle. Housewives who took advantage of the advice appreciated its effectiveness.

What happens if you don’t level the body of the machine?

If you do not adjust the legs of the automatic machine to the level, you can achieve adverse consequences. Firstly, an uneven position is very harmful to the washing machine and inevitably leads to damage to the internal elements. Secondly, the situation with equipment always “running” around the room, rattling during the spin cycle, is uncomfortable for all family members and even neighbors downstairs.

What parts fail first?

Dampers. Shock-absorbing elements are necessary to dampen housing vibrations. If installed unevenly, the springs wear unevenly. So, just a year or two after purchase, the components will have to be changed.
Bearing unit. Even a misalignment of the washing machine that is invisible to the eye puts an increased load on the bearings. If when washing a couple of things the negative impact is not very large, then with a cycle with a full drum it will be significant.

The cost of repairing a washing machine when replacing bearings is very high. You will have to pay a technician to completely disassemble the machine, remove the tank, divide it into two parts, remove it and install a new bearing assembly.To this should be added the amount spent on the purchase of spare parts and lubricants.

dampers wear unevenly

Dampers are also replaced as a “set”, so the costs will be considerable. It is better to immediately adjust the legs of an automatic machine than to eliminate the consequences of improper installation of equipment in the future. If you do not know how to make the adjustment, invite a service center technician.

It is necessary to adjust the washing machine correctly to avoid stagnation of liquid inside the equipment.

In a “skewed” machine, a place appears in which water constantly accumulates, and the pump cannot pump it out completely. This is fraught with an unpleasant odor, “colonization” of the machine with microbes and the formation of mold.