How to clean the drain hose in an LG washing machine?

How to clean the drain hose in an LG washing machine Sooner or later, the owner of an LG washing machine will need to clean the drainage hose with his own hands. It is no secret that waste water, passing from the drum to the sewer, leaves particles of debris and soap deposits on the machine parts. The rubber walls of pipes are no exception, and over time a thick sticky layer accumulates here, which threatens serious blockage. There is only one way out - regularly remove accumulated dirt. We will learn how to do this from the article.

Removing the hose

To clean the drain hose of an LG washing machine, it must be disconnected from the machine body and disconnected from the sewer. This is not difficult to do: just turn off the power to the machine, tilt the washer back, leaning it against the wall, and pay attention to the bottom. We cover the area around with rags, open the technical hatch, carefully twist the leakage sensor and find the location for installing the rubber tube. Loosen the retaining clamp and pull the pipe towards you.

It is recommended to clean the drain filter and pump impeller at the same time as the hose.

The second end is even easier to disconnect. We find where the rubber band joins the siphon or sewer riser, loosen the clamp and release the tube. That's it, dismantling has been successfully completed, and you can start cleaning the hose. remove the drain hose

Description of the cleaning process

There is no need to rush to grab water and soap: it is better to first carefully inspect the removed hose. Before you start cleaning, you should make sure that the rubber is intact, and if there is damage to the casing, you will need to replace it. Otherwise, unpleasant surprises with leaks will await you later.

You can remove most of the dirt by running an hour-long wash with baking soda and vinegar.

The cleaning itself is carried out using a special non-metallic Kevlar cable. There is a small brush at the tip, which is used to remove accumulated soap scum. To do this, just follow a couple of simple steps.

Insert the device into the hose and, moving back and forth, remove the layer of dirt from the walls of the tube.
Repeat the procedure several times until optimal cleanliness is achieved.
Rinse the hose under strong pressure of hot water.

Instead of a Kevlar cable, a homemade analogue is suitable: bend one end of a long steel wire into a loop and tightly wrap a piece of fabric around it. The main thing is that the “brush” matches the diameter of the tube. In this case, the cleaning process is no different - insert, clean, rinse.

What causes the hose to clog?

Clogging of the hose is almost inevitable: washing powder and lint from clothes will still begin to settle on the walls of the tube. Such clogging is considered natural for all washing machines, regardless of manufacturer and model. However, it is possible to slow down the process of plaque formation if you apply the following recommendations in practice:

wash clothes in special protective bags;
do not neglect water softeners;
after finishing the wash, run an “empty” cycle to rinse the machine;
Clean the washing machine regularly;

It is recommended to carry out a comprehensive cleaning of the washing machine at least once every three months.

use high-quality detergents designed specifically for automatic machines;
Before loading into the drum, check the pockets of things, shake off hair and dust from the fabric.

Removing the drain hose and clearing it of accumulated dirt takes 5 minutes.The main thing is to act carefully, confidently and according to instructions.