Waterproof error on Miele washing machine
If the display shows the Waterproof error on your Miele washing machine, then the first thing you need to do is disconnect the equipment from the power supply and turn off the water supply. In this case, you need to act quickly, observing safety precautions. Only after completing these steps can you begin to find out the cause of the breakdown.
What will we do first?
As soon as you stop the power supply, you need to inspect the machine. If you discover a leak and the space around the washing machine is flooded with water, then the Waterproof protection system is activated to save the equipment from leaking. If the area around the machine is dry, then you need to remove the front panel and inspect the tray. However, this is not the first need. Initially, you should tilt the washing machine body forward and then back.
This action can help correct the error and ensure that there is water in the pan. In a tilted position, water will splash out of the pan onto the floor. Also, using these actions you can return a “stuck” system float to its place.
When the washer displays the Waterproof error, you also need to inspect the powder tray. If you pulled it out not long ago, then the essence of the problem may be hidden in this. If the powder tray is not installed correctly, water may enter the washing machine tray. You need to check the tray and install it in the correct position.
Inspecting the pallet
To inspect the pan, you need to disconnect the washing machine from the water supply and sewerage system. Then you need to move it to the middle of the room and lay rags on the floor. After this, you need to tilt the body of the machine to the side and pour water from the pan.Then put it on the right side and unscrew the pan.
When removing the pan, care must be taken not to tear off the wire that powers the protection sensor.
If there is no water in the pan, then you need to lower the float and put the pan in place. In this situation, there is no need to carry out repair work, since the reason will be a “stuck” sensor. If, however, there is a large amount of water in the pan, then you need to inspect the pipe that goes from the tank to the volute, the drain filter and pump, as well as the tank itself for any defects. As a rule, the location of a leak can be detected immediately, since drops of water are noticeable in this place or a wet spot is visible. A broken spare part must be completely replaced, but you can also use a sealant to eliminate the cause of the breakdown with your own hands for a short time.
Checking and replacing the sensor
The sensor responsible for the leak can operate regardless of the location of the float. In the current situation, its complete replacement is required. What to do in this case to fix the washing machine and how to understand that this is the reason? To do this, you need to inspect the float and check the sensor using a multimeter. If it is located in the down position and has not moved, but still works, then it must be replaced. To do this you need to do the following:
- remove the power wire from the sensor;
- unscrew the fasteners;
- remove the sensor and buy a similar one in a specialized spare parts store;
- replace the spare part.
After this, we assemble the Miele washing machine in the reverse order and continue to operate it. Protection systems help prevent major troubles. For these purposes, washing machines are equipped with a “Waterproof” error code.It alerts you to problems with water, although the problem may be in the sensor. Thanks to this system, serious equipment breakdown can be avoided.
Interesting:
5 reader comments
Please tell me, if the machine is built into furniture and the front of the machine is covered with MDF, the door is blocked. Is it possible to dry the water from the tray somehow? Maybe a hairdryer? After cleaning the filter, some water got into the tray and the Waterproof error message appears. There is no way to pull out and tilt the machine.
No. It is forbidden.
Thank you, kind man :) I fixed it
Good night? The green start button is not lit.
Is it possible to do something yourself?
The Waterproof error is on, how to fix it?