Where is the filter located in a Samsung washing machine?

Where is the filter located in a Samsung washing machine? The manufacturer recommends periodically cleaning the parts of household appliances to extend their service life to 10-15 years. This is not difficult to do if you know where the Samsung washing machine filter is located, how to unscrew it and how to clean it from dirt and scale. The main thing is to act carefully and not deviate from the given instructions.

Part Search

Modern Samsung washing machines have a filtration system. More precisely, we are talking about two filters that are located at different “ends” of the machine. Despite their excellent location and design, they perform the same function - they protect the washing machine from debris and other foreign objects. The following filters are installed in the machines:

Jellied. It is located at the very “entrance” to the machine behind the inlet hose. It is necessary for the primary purification of water from impurities, scale, rust and small debris, which the central water supply system is “rich in”.
Drain. Also called drainage and garbage, and unlike the filler, it is located at the “exit” of the machine. The “garbage bin” protects the pump and sewer hose from debris and foreign objects getting into the drum with things. For example, if coins or keys fall out of your pocket during washing, the filter stops them, preventing them from passing through the drain, blocking the impeller and damaging the pipes.

The manufacturer recommends installing additional filters in the washing machine to soften tap water.

Most often, the “trash bin” needs cleaning. Determining the location of the drain pump filter is not difficult - just find the technical hatch door in the lower right part of the housing.All that remains is to pry the part with a flat screwdriver and unclip the latches. It’s also easy to spot the filling “mesh”, which is hidden next to the filling hose. It's easy to understand when filters need cleaning. You just need to “detect” the signs of a blockage. The garbage filter is located at the bottom front

Signs you need cleaning

The first thing that will react to a blockage in the filtration system is the self-diagnosis program. Modern Samsung washing machines are equipped with intelligent control, which allows them to automatically respond to malfunctions of internal parts. The main thing is to know what error codes indicate contaminated “garbage bins”.

Thus, combinations 5E, 5C or E2 indicate problems with the drain and garbage filter, and 4E, 4C or E1 indicate poor water intake. When the electronics do not work, you will have to guess the problem through secondary signs. We are talking about the following “symptoms”:

the water drains very slowly;
the drum does not empty at all;
the machine stopped, but did not drain the water;
the laundry was poorly wrung out;
the system automatically canceled rinsing and spinning;
The washer does not draw water and does not start the cycle.

Another warning “symptom” is an unpleasant odor coming from the washing machine. Accumulated debris under the influence of detergent begins to rot and release the corresponding “aroma”. But it’s better not to delay until the last minute, but to clean the filters as planned.

Cleaning the garbage filter

Let us repeat that the garbage filter is “hidden” behind the technical hatch door. We unclip the latches, find the emergency drain tube and drain the remaining water in the machine. First place a rag, old newspapers or a container under the hole. Next we proceed like this.

Unscrew the screw holding the trash can.
We take the filter handle and rotate it counterclockwise.
If the filter does not work, treat the part with a cleaner such as WD-40 and wait 20-30 minutes.
We take out the spiral.

Now let's move on to the actual cleaning. Remove dirt and rinse under the tap.

Cleaning the intake valve screen

Before cleaning the filler filter, disconnect the machine from communications. Then we move the body away from the wall, place the container and disconnect the inlet hose. Next, we find the mesh and use pliers to remove it from the sleeve. cleaning the filling valve mesh

The mesh is cleaned under the pressure of warm water. In case of severe contamination, treat the filter with soda and a brush, soak it in a lemon solution, or replace it with a new one.